← All posts

Designing Bridges, Tunnels and Flyovers That Work

November 15, 2026 ยท 2 min read

Raising a road segment into a bridge with ramps in the Fiza3D 3D view

A flat road network is easy to read but rarely memorable. Bridges, tunnels and flyovers add vertical variety, create landmarks and let routes cross without a junction. They are also easy to get wrong. This guide covers when to use each and how to avoid the classic mistakes.

When to use a bridge

Use a bridge to cross something the player should see: a river, a valley, another road. Bridges are natural landmarks, and they give you a high vantage point. A raised road also separates fast through-traffic from local streets, which is how real highways work.

When to use a tunnel

Tunnels hide things. They cut through hills, pass beneath dense districts, and give a map a sense of scale. They also change the mood: a tunnel is a pause, a place where lighting and sound can change. Use them sparingly so each one feels like an event.

Ramps are the hard part

The slope of the approach decides whether a bridge feels natural. Too steep and vehicles struggle or players lose control. Too gentle and the ramp eats half your map. Allow enough run for the height you need, and keep the approach straight so players can see where they are going.

In Fiza3D you switch a road segment from Ground to Bridge or Tunnel and set how high or deep it goes. The ramps are generated for you, with piers down to the ground for bridges and lined tubes for tunnels.

Check clearance before players do

The most common flyover bug is a road that passes over another with too little room underneath, so a truck or bus would not fit. It is easy to miss in a plan view and obvious in play. Decide on a minimum clearance for your tallest vehicle and check every crossing against it.

Fiza3D does this check for you. When one road crosses another, it measures the gap and shows a plain-language warning with the exact numbers in the inspector, plus a live counter in the status bar. You fix it by moving or raising a road.

Terrain matters

A tunnel needs something to go through, and a bridge needs something to cross. Sculpt the terrain first so the structure has a reason to exist. Underpasses that cut through embankments look far more believable than a tunnel under flat ground.

Checklist

New to the series? Start with how to design a road network for a game level.

Build your first 3D map

Join the Fiza3D waitlist and be first in line when it opens up.

Join the waitlist